[ Pobierz całość w formacie PDF ]
Relevant to lightweight single story buildings, garages, sleep-outs, sheds etc.
Identifying the members:
1.
Wall Framing, excepting headers, is usually of 100x50 (2x4) stock, for perimeter or bearing
walls. Internal non-load bearing walls can be of 75x50 (3x2) stock.
Partly cut underside of Bottom Plate at each side of doorway before standing the wall frame
up. This is to enable the Bottom Plate in the doorway to be cut out (from the top side) when
the Wall Frame has been squared, straightened and fixed in place.
BLOCKING: Short nogging. Block to separate two studs.
BOTTOM PLATE: Wall plate, sole plate; The bottom horizontal framing member of the wall
CRIPPLE STUD: Short studs placed between the header / lintel and a top plate or between a
sill and bottom plate.
HEADER: Lintel; A beam placed perpendicular to wall studs above doors, windows or other
openings, to carry the weight of structural loads. The Header is usually two 50 (2") thick
pieces of lumber nailed together to form one 100 (4") thick piece. The width of the Header
depends on the required span.
NOGGING: Dwang; A short piece of timber set between two studs, joists, rafters or purlins to
keep them rigid.
ROUGH OPENING: Trim size; The framed-in opening, slightly larger than the actual
window/door, that replaces wall studs to support the structure and accommodate a
window/door.
STUD: A 100x50 (2x4) vertical framing member used to construct walls.
TOP PLATE: The top horizontal framing member of the wall.
TRIMMER: Under stud; Framing member that is cut to fit between the bottom PLATE and the
HEADER
.
Marking the Top and Bottom Plates for Studs:
First of all, cut all the Wall Plates in place, top and bottom and place on the floor or surface where
they are intended to go, just to make sure that they all fit according to plan.
2.
Take the top and bottom Wall Plates of one wall, temporary nail or clamp together and place on a
couple of saw stools for marking Stud and Trimmer Stud positions.
The overlapping Wall Frame has a double Stud at the overlap end separated by blocking pieces that
are usually the same thickness as the Studs.
Placing and fixing the Studs:
Lay and fix the Studs in place between the Top and Bottom Plates. If the Studs are not straight, lay
with the bow upwards.
3.
The length of the Stud should be the required ceiling height less the thickness of the Top and Bottom
Plates as well as the thickness of the ceiling lining as well as a bit to play with, say 10mm (3/8").
Placing and fixing the Noggings:
4.
Fix the Noggings and Blocking in place between the Studs. At least one row of Noggings can help
minimize twisting and warping.
Placing and fixing the Trimmer Studs and Headers:
Lay and fix the Trimmer Studs and Headers in place. The Header is usually two 50 (2") thick pieces of
lumber nailed together to form one 100 (4") thick piece. The width of the Header depends on the
5.
required span.
The width and height of the Trim size (Rough opening) should be slightly larger than the actual
window or door finished frame size, by at least 10mm (3/8") .
Placing and fixing the Cripple Studs:
6.
Just the Cripple Studs to go, which are the short Studs between the Header / Lintel and a Top Plate
or between the sill and Bottom Plate.
The Wall Frame is now ready to be squared and lifted into place. The Wall Frame is square when the
Wall Plates are straight and the distance between the opposing diagonals are equal.
[ Pobierz całość w formacie PDF ]